Drive cam is set in the near top and the center of windshield and both forward facing lenses and they lenses capture video as well as audio, device will show solid green light on right side until its record, it will automatic green to red during recording based on the event like hard braking or acceleration hardwww.drivecamlogin.com
Installation of event recorder is not complicated but care must be taken to ensure successful operation, follow these instructions carefully to ensure proper orientation and operation
Dry and clan your windshield
1 selects the top location on the glass behind rear view mirror on the passenger side of your vehicle.
2. Use an alcohol pad to clean the mounting area.
3. With the using of dry and clean cloth dry the mounting area.
Select mounting location carefully
1 you lose the Torx screws so event recorder rotate in the bracket
2. Pull your mirror down to Lowe position
3. Position assembly behind mirror about one inch to the right of the post for easy access.
Mark the mounting location on the glass
1. If you selected best location hold assembly and www.drivecamlogin.com trace the outline of the bracket. Have a look at those benefits that can be for installing cameras in your truck.
2. Here you remove event recorder from the bracket
3. Check fit bracket against the windshield.
Interconnect cable
1. Here you starting just above rear view mirror cable under window trim headliner to the door.
2. Router cable down door pillar underneath and window trim.
Electrical connection
Only three required connection for recorder here is the red wire it is for primary power must be connected with power, the brown wire stands for ignition since it helps to the recorder to event sense, power and the ignition sense provide protection through cable access.
No comments:
Post a Comment